• SoC Platform
 
Part No. (Name) Vendor Description Format  
GP1680 GUC Surveillance SoC Platform SoC  
GP5080 GUC Solid State Disk SoC Platform SoC  
         
  • GP1680 Surveillance SoC Platform

GP1680 is highly integrated SoC for surveillance applications. It supports 4 channel video inputs and deploys a quad module that composes four videos into one screen for preview application. The display layout on the screen is programmable. Motion detection function can issue an interrupt if there is a motion captured by the camera. The sensitivity and area of interest are programmable. Each H.264 engine is capable of D1 resolution (720x480) image at 30 FPS frame rate. D1 and CIF (352x240) mode are supported. H.264 is the format when video is saved. GP1680 equips four H.264 Encoders and H.264 Decoders for video recording and playback. Videos can be saved to hard disk through PCI, IDE interface or save to SDIO / USB OTG interface. The remote PC can access GP1680 through Ethernet. The TV encoder can display the video decoded by the H.264 Decoder for playback from Hard disk. There are digital audio interface per each channel for audio recording and playback. In addition, GP1680 support multi-chip solution through PCI bus for up to 16 channels D1 DVR application..


Key Features
  • H.264 CODEC engine
  • 4 CH D1 120 fps Encode and 4CH D1 120 fps Decode full duplex
  • MJPEG CODEC engine
  • 1 CH/ 4 CH/ 9 CH/16 CH Preview, Record and Playback
  • 4 CH digital audio interface record and playback
  • ARM926E Embedded
  • PCI Cascading solutions for 4/8/16 channels application
  • NTSC / PAL TV out function
  • 4 Channel CCIR656 video input and Motion detection
  • ATA / SDIO2.0 / PCI / USB 2.0 OTG (PHY) x2
  • 10/100 Ethernet MAC
  • OSD / 2D graphic engine / 4 layer overlay
  • EV Board, SDK , Linux tool chain and Reference Application Software
  • DVR reference design platform
  • 90nm process low power consumption
  • PBGA729 35mmx35mm RoHS package

Application
  • Standalone DVR/NVR application
  • Portable and Mobile DVR application
  • IP Camera

Block Diagram

 

 
  • GP5080 series 4ch SSD SoC Platform

GP5080 series is a highly integrated SoC platform designed for the high-performance and lower-power consumption Solid State Disk (SSD) application.
The architecture of GP5080 series has been optimized to fully utilize the maximum data transfer of NAND flash. It supports 4-channel access and each channel could operate independently to deliver excellent sequential and random Read/Write performance with Samsung, Toshiba, Hynix, Micron, and IM up-to-date SLC/MLC 2K/4K page size NAND flash. It enables SSD to become a powerful system disk when running OS and handling lots of requests for small file access. Besides, the on-chip hardware BCH-ECC engine which could correct up to 16 bit errors per 512 byte data makes SSD more reliable.

GP5080 series features 32-bit ARM7 processor to improve SSD’s performance, lifetime, and reliability by providing higher computing capability for firmware such as Flash Translation Layer, Bad Block Management, Wear Leveling Algorithm, Power Fail Recycling, SMART function etc. In addition, it supports PATA and SATA2 dual interface which are most common interface for storage devices. With SDRAM interface, it supports cache function to greatly enhance write performance and extend SSD’s lifetime by reducing the Program/Erase count..


Application
  • SSD or Flash module for Netbook, MID, Notebook and Industrial Application
  • eSATA Flash Disk and High-speed Pen Drive

Key Features
  • 32-bit ARM7TDMI
  • PATA (up to 133MB/s), SATA2 (up to 3Gb/s) dual interfaces
  • SLC/MLC NAND Flash controller (4 channels, 8 banks, total 32CEs)
  • Each flash channel access independently
  • Hardware BCH-8/14/16 (SW configurable) ECC engine
  • SDRAM interface
  • Wide Operating Temperature: -40°C ~ +85°C
  • Performance Index:
    – Sequential Read: over 120MB/s
    – Sequential Write: over 80MB/s
    – Random Write IOPS@4KB: over 200 (w/o SDRAM)
    – Random Write IOPS@4KB: 300-500 (w SDRAM)
  • Power Consumption:
    – Active mode:79mA(3.3V),69mA(1.0V)
    – Sleep mode:7mA(3.3V),19mA(1.0V)
  • EV Board, SDK, Tool chain, and Reference Application Software

Product Line
Part No. (Name) Description
GP5080 4-ch SATA2/PATA SSD Controller
Package: TFBGA255, 11mm x 11mm
GP5086 4-ch SATA2/PATA SSD Controller with SDRAM interface
Package: TFBGA300, 13mm x 13mm
   
Block Diagram

For other IP requests, please contact sales representatives for details.
 

Legal statement  | Sitemap   Copyright © 2010 Global Unichip Corp. All Rights Reserved. Best view by 1024*768 with I.E 5.5 and upper